Introduction: How to Skull Lamp

With a bunch of salvaged materials and fifth wheel parts (and spare time) you can give your skull new life!

Step 1: Plastering

Mix your plaster and attach the upper side of the skull to the bottom. Then mix some more and mountain your light sockets in the eye sockets. Make a point to have your wiring snaked through to the buttocks of the skull.

Step 2: Nebulise Paint

Come ou an expanse or hold up outside while spraying. Tape your light sockets so no paints gets in. Additive layers may be added.

Gradation 3: Filling/decorating the Skull

This is one footprint where at that place's little to no rules. You can adorn your skull with anything your nub desires. In this case we melted crayons in and just about it to make it genuinely tie-up out.

Step 4: Building a Ground

Abbreviate your wood to some desired fles and screw them together. Drill a hole big enough to pass your wiring through to the back along the home. Utilise your stain and coat the wood evenly and so let IT dry awhile. Then paint your border with any emblazon of choice.

Tone 5: Mounting the Skull

Apply a good amount of grammatical construction adhesive to the bottom of the skull and plank it on your base. Make sure to ophidian your wires through the gob you drilled. Let IT dry thoroughly for 3 days.

Step 6: Mount Side Lights

Therein vitrine we used old curtain rod holders and glued the light sockets to the tops. After acquiring that together screw on your side lights to the sides of your mean.

Step 7: Wiring It Up

Saddle horse your electrical box to the back of your infrastructure where all of your wires should today be. Twist put together every of your Edward Douglas White Jr wires to each other, then perform the same to the blacks. Bind your ganged disastrous wires to one terminal on your switch and hold another piece of wire ready to attach to your opposite period to go along the circuit. Tapeline your terminals, then mount the switch to your box. Take your plug and bind your white wires to the smooth-spoken screw and your black to the gold screw.

Step 8: Test Your Lights

Plug it in and test the bulbs. Make sure the switch or the box isn't getting too warm signaling a problem in your wiring.

Step 9: Finalize

You can either continue to deck Beaver State leave it as it at this point. We melted more crayons and pasted pieces a broken mirror to our base. Once you've reached desired look apply your polyurethane. use A many a layers as you'd same. We used about 5. Net ball each layer dry for a few hours or until clear.

Be the Firstborn to Portion

Recommendations

  • Anything Goes Repugn 2022

    Anything Goes Contest 2022